Kramer Power Equipment Co. Industial Welding and Machining

 

Services
Bore/Turn
Keyway Broaching/
Keyseating

Milling
Drill & Tapping
Sprocket/Gear Heat Treat
Welding & Fabrication
Steam, Oilfield, and Gas Engine Restoration
Good News

About Us
Equipment List
Quality
Taper Gage Inventory
Map & Directions
History
Contact Us

Suggestions?
Table of Contents

 

 

 

 

Drill and Tapping

Drill

We have two automatic drill and tap machines for products such as sprockets, gears and sheaves.  There are also several drill presses and one radial arm drill press for very large parts.  We commonly drill and tap products for setscrews in both inch and metric sizes.   Drill & tap chart

Broken Tap In A Part?
We have a tap disintegrator that we can burn the broken tap out of your valuable part.  It is a much cheaper process than EDM.

Setscrew
We are able to install almost any size, length, or style of setscrew available.  The setscrew can be located almost anywhere the customer may want.  Uncommon setscrews may have to be ordered, so please allow time.  Listed is the tap sizes we do most often.
#6-32     #6-40   M5-0.8  
#8-32   #8-36  M6-1.0  
#10-24  #10-32 M8-1.25
1/4-20 1/4-28 M10-1.5
5/16-18  5/16-24 M12-1.75
3/8-16     3/8-24  
7/16-14       7/16 - 20  
1/2-13    
5/8-11    
3/4-10    
7/8-9    
1-8        

 Style of Setscrew
Standard - Knurled cup point
Plain cup point
Cone point
Nyloc  (Self locking)
Square Head

 

Email box 2388 State Route 726
  Eaton, Ohio 45320
(937) 456-2232 Fax (937) 456-2282
webmaster@kramerusa.com
2004-2017 Kramer Power Equipment Co. All rights reserved.